Substitution of steel: steel material should strengthen planning and timeliness of supply, to avoid the construction process reinforced substitution. In terms of 8.5mm cold-rolled steel straight when another wholesale rebar steel or rebar diameter specified in the design documents instead, should comply. Reinforcement spacing regulations, anchorage length, the minimum structural requirements such as bar diameter. At a high level, low level of reinforced steel substitution, should adopt the method to change the diameter of the steel should not be used to change the number of ways to reduce the cross-sectional area of ??reinforcement. Reinforced Construction Notes: Dimensions steel skeleton allowed, when a plurality of steel banding should be aligned with the ends of 8.5mm cold-rolled straight rebar prices, prevent banding, a deviation from the prescribed location and number of reinforced skeleton distortion. The thickness of the protective layer of mortar pad should be accurate straight cold-rolled steel, cold rolled 8.5mm pad spacing should fit straight rebar spot, otherwise lead to flat plate surface cracks cantilever beam pillarless side exposed tendons. After lashing steel skeleton is complete, there will be an oblique side, while lashing wire should be tied into a figure eight around the mouth lashing found stirrup missing, wrong to timely adjust the pitch. 8.5mm cold-rolled straight rebar spot | Dingding cold rolled | Cold rolled straight Shandong, Henan Province, Ding Ding by rebar Industries Limited. Ding Ding Industrial Co., Ltd., Henan Province (www.hnddsy.com) is Anyang, other leaders, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. In cold-Ding Ding leadership with the staff warmly welcome all inquiries negotiations to create a better future for cold-Ding Ding.