Steel banding specifications: the base cushion cleaned steel construction, with a slate pencil and fountain bomb placed in the top line of steel reinforcement. Line of position by laying the foundation of reinforced steel. Steel banding. Around the intersection of the two lines should be reinforced every point lashing prison. Middle section can be separated staggered intersection pitched, but must ensure that the reinforced not shift. Bidirectional reinforcement steel mesh, you need to pay all pitched reinforced intersection point. Adjacent wire lashing point deduction to start building character rebar plant, in order to avoid wind-chip skew distortion. Steel specification: steel installation location, spacing, and the part of the protective layer of steel sizes, shall comply with the provisions of the design documents. Steel banding. Spot welding or banding steel mesh construction rebar suppliers, connecting its steel intersection interval by 50% binding, but the bar diameter less than 25mm, the peripheral layer of steel mesh floor and wall crossing point by point should be banding. Design requirements should be specified at the time the design. Construction rebar manufacturers | Dingding cold-rolled (certified) | Henan construction rebar provided by Ding Ding Industrial Co., Ltd., Henan Province. Ding Ding Industrial Co., Ltd., Henan Province (www.hnddsy.com) is Anyang, other leaders, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. In cold-Ding Ding leadership with the staff warmly welcome all inquiries negotiations to create a better future for cold-Ding Ding.