Steel storage: steel brought into the processing site, the factory must have quality certificate or test report single 9mm steel plant, each bundle (disk) should be reinforced hang signs, should be marked with signs marked plant, steel products batch number, specifications, dimensions and other markers, not damage and loss of these signs during transport and storage. The arrival of reinforcement should be solely on the basis of different grades, grade, size and manufacturer of batch acceptance check the appearance quality of each batch of steel quality based on the original certificate attached or test certificate. Reinforced Construction Notes: Dimensions steel skeleton allowed, when a plurality of steel banding should be aligned with the ends, to prevent banding, a deviation from the prescribed location and number of reinforced skeleton distortion. The thickness of the protective layer of mortar pad should be accurate 9mm steel manufacturers, pad spacing should be appropriate, otherwise lead to flat plate surface cracks 9mm cantilever steel beam pillarless side exposed tendons. After lashing complete 9mm rebar steel skeleton stock, there will be an oblique side, while lashing wire should be tied into a figure eight around the mouth lashing found stirrup missing, wrong to timely adjust the pitch. 9mm steel manufacturers | Dingding cold-rolled (certified) | 9mm steel provided by Ding Ding Industrial Co., Ltd., Henan Province. Ding Ding Industrial Co., Ltd., Henan Province (www.hnddsy.com) is Anyang, other leaders, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. In cold-Ding Ding leadership with the staff warmly welcome all inquiries negotiations to create a better future for cold-Ding Ding.