Crosspoint steel skeleton and steel mesh should adopt resistance spot welding. Steel and cold-rolled steel T-connector straight rebar, should adopt the submerged arc welding or arc welding pressure. On a common set of reinforced joints should be less. Steel joints should be located in a small section of the force, not at the maximum bending weaknesses member. In either welded or lashing joint length segments, with a steel rod shall have two connectors. Reinforced Transportation Note: temporary stacking steel, not over-concentration of stacking space should consider carrying capacity. When the manual handling of steel, to be consistent pace, when turning on the downhill or straight 6.5mm cold-rolled steel supplier, after going to the front should call 6.5mm cold-rolled strip steel production plant straight, steady pace is slow, pay attention to steel head and tail swing, prevent collision objects or impact the human body, especially to prevent the collision hang around and up and down the wire, upper arm or unloading To greet each other, we must pay attention to safety. 6.5mm cold-rolled straight cold-rolled steel production plant _ _ Dingding cold rolled steel straight by Ding Ding Industrial Co., Ltd., Henan Province. Ding Ding Industrial Co., Ltd., Henan Province (www.hnddsy.com) is Anyang, other leaders, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. In cold-Ding Ding leadership with the staff warmly welcome all inquiries negotiations to create a better future for cold-Ding Ding.