Reinforcement should be at room temperature, 8mm rebar bending procurement, not heated. Reinforcement should gradually from the middle to the ends of bending, the hook should be bent once. 8mm rebar steel processing manufacturer, should be taken to prevent the collapse of oil, mud and other pollution and measures to prevent damaged. Steel connection: reinforced joints should be welded joints or mechanical connectors. Welding flash butt joints should be preferred. In the absence of welding conditions, can be used to connect high-quality 8mm steel banding, but the tension member shall not be used in the main steel banding connection. Reinforced Transportation Note: mechanical vertical lifting steel, should be firmly lashing, hanging points should be located at both ends of the tendons 8mm rebar, while difficult, was in the center of gravity of the beam steel hanging point set, steel should rise steadily, not overweight lifting. When lifting steel or steel skeleton, lifting staff must wear helmets, ban to stand underneath, until the steel skeleton from the landing to the ground floor level or security personnel are allowed within one meter near the action. 8mm rebar manufacturers, Ding Ding cold rolled (certified), 8mm rebar by Ding Ding Industrial Co., Ltd., Henan Province. Ding Ding Industrial Co., Ltd., Henan Province (www.hnddsy.com) is Anyang, other leaders, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. In cold-Ding Ding leadership with the staff warmly welcome all inquiries negotiations to create a better future for cold-Ding Ding.