Rebar form factor: the surface shape and size ribbed steel tolerances. Ribbed steel horizontal rib design principles should meet the following requirements: the angle β transverse ribs and reinforced axis of not less than 45 degrees, when the angle of not more than 70 degrees 9.5mm steel stock, reinforced on opposite sides in the direction transverse ribs be contrary; transverse ribs is not greater than the nominal spacing l reinforced 0.7 times the nominal diameter; transverse ribs and reinforced side surface of the angle α of not less than 45 degrees; reinforced the gap between the ends of adjacent transverse ribs (including a longitudinal rib width) on both sides should not be greater than the sum of the nominal 20% reinforced perimeter. Ribbed steel usually with longitudinal ribs, or without longitudinal ribs. Steel specification: basic steel installation: cast columns, walls and foundation connected with the lower end of the dowels, with 90 ° hooks and steel banding 9.5mm foundation rebar, dowels location-based applications into well-shaped steel frame fixed firmly 9.5mm steel manufacturers, reinforced pillars to avoid displacement. When the base is equipped with double steel mesh reinforcement brace should be set in the upper steel mesh below to ensure the correct upper and lower reinforcement spacing and location. 9.5mm rebar prices | Dingding cold rolled | Henan 9.5mm steel provided by Ding Ding Industrial Co., Ltd., Henan Province. Ding Ding Industrial Co., Ltd., Henan Province (www.hnddsy.com) is Anyang, other leaders, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. In cold-Ding Ding leadership with the staff warmly welcome all inquiries negotiations to create a better future for cold-Ding Ding.