Steel banding specifications: reinforced the connection: connection reinforced joints should be set at a smaller force. Fitting end to the start of rebar bending distance of not less than 10 times the bar diameter. The use of banding lap joints 12mm rebar factory outlets, the joint with longitudinal reinforcement banding joints should be staggered; steel banding shuttle connecting segment length is 1.3 times the length of 12mm rebar lap wholesale, where the lap joints point is the section of the lap joint connections belong to the same segment, located in an area of ??tension steel lap joint by the same percentage of 25% within the sector. Reinforced Construction Notes: enter the construction site personnel must be properly qualified wear a helmet, fasten your chin with 12mm rebar, lock buckle. Must be used correctly when the job required personal protective equipment, dress neatly 12mm rebar models, non barefoot and wearing slippers, high heels into the construction site. In the absence of reliable high security facilities (including 2 m 2 m or more) and a steep construction, you must fasten qualified seat belts, seat belt to fasten securely hang, hanging low with, at the same time work at heights not wear hard ground with nails and slippery shoes, wear non-slip shoes. 12mm rebar factory outlets, cold-Ding Ding, Shandong 12mm rebar is provided by Ding Ding Industrial Co., Ltd., Henan Province. Ding Ding Industrial Co., Ltd., Henan Province (www.hnddsy.com) is Anyang, other leaders, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. In cold-Ding Ding leadership with the staff warmly welcome all inquiries negotiations to create a better future for cold-Ding Ding.