Steel manufacture, steel wire rod surface should be clean and 10mm rebar spot, 10mm rod must be clean before sticking rebar supplier of oil, dirt, rust using rust can be combined with cold drawing process. Steel wire rod straight 10mm rebar plant, mechanical or manual available straightening. After straightening the steel shall have local bending, bending die, little wavy 10mm steel wire rod, rebar surface section scars should not be reduced to 5%. Reinforced steel cutting should be based on number, diameter, length and number, the length of match, first off a long break after a short feed material, minimize and shorten the steel short head, in order to save steel. Bent steel. Bending diameter D at the middle of the bend, no less than five times the bar diameter. Stirrups. Should be the end of the stirrup hook, hook form should meet the design requirements. Stirrup adjustment, namely to increase the length and curved hook adjustment or difference between the value of the two and, according to the hoop size or the amount of outsourcing package size. Steel cutting length should be considered based on component size, concrete cover thickness, steel bending adjustment value and increase the length of the hook and so forth. 10mm rod rebar suppliers | 10mm rod rebar | cold-Ding Ding Ding Ding Industrial Co., Ltd., Henan Province by. Ding Ding Industrial Co., Ltd., Henan Province (www.hnddsy.com) strong, credible, and other industries in other Anyang accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead Dingding cold rolling and you hand into the brilliant, for a better future!